Whitetopping is laying of Portland cement concrete on the top the existing asphalt pavement.
The thickness of this concrete layer varies and depends upon the bonding between the asphalt and the concrete layer.
- Unbonded whitetopping, also called conventional whitetopping, uses concrete thicknesses of eight inches or more that is not bonded to the asphalt.
- Bonded whitetopping uses thicknesses of two to six inches bonded to the asphalt pavement and is divided into two types, thin and ultrathin. The bond is made by texturing the asphalt.
- Thin whitetopping uses a bonded layer of concrete that is four to six inches thick while an ultrathin layer is two to four inches thick.
- Ultrathin whitetopping is suitable for light duty uses, such as roads with low traffic volume, parking lots and small airports. Fiber reinforced concrete is used in some thin whitetopping overlays and almost all ultrathin whitetopping overlays.
 |
| image source : Unzeen |
Whitetopping is suitable for asphalt pavement with little deterioration, although repairs can be made to the asphalt if necessary. If the pavement is badly damaged, it should be completely removed and a new concrete pavement should be installed. The pavement should be relatively hard, as well.
Deterioration of overlays is significantly increased on asphalt bases with high viscosity. If a grade or a distance between the pavement and a bridge needs to be preserved, the asphalt can be milled so that the height of the pavement does not change.
However, whitetopping requires the asphalt layer to be at least three inches thick. If necessary, a section of new concrete roadway can be placed under a bridge with gentle slopes on either side that meet up with the whitetopped portions of the road.
Sources: Wikipedia
Civil Scholar is a Blog by Aravind Samala on Construction, Environment, Technology, Trends and Innovation.